Power-Sonic

Dispositivos Suportados

Device Type	Modbus TCP (Ethernet)	RS485	Curtailment
PS-PULSE-INV-6KW	❌	✅	❌
PS-PULSE-INV-8KW
PS-PULSE-INV-10KW
PS-PULSE-INV-12KW

Fiação

RS485

RS485 Wiring

• For correct RS485 wiring: Follow the guidelines for RS485 wiring.
• If the wiring shown in the table below is incorrect, please let us know.
• There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	Sofar EMS model OM1	Sofar EMS model IG8	RS485-USB converter	RS485-Ethernet converter
	RS485 A	RS485_POS	RS485 A	TX+
	RS485 B	RS485_NEG	RS485 B	TX-
	RS GND	GND	Not available	G

Configuração

NOTE: RS485 Device Addresses

• You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
• Use lower addresses first (1, 2, ...) because the Sofar EMS will find them faster!
• For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The Sofar EMS will scan on those first.

1. Defina o modo de operação como Auto Consumo

2. Defina Zero Export como Desativar

3. Defina Controle Remoto como Ativar

4. Defina o endereço RS485. A taxa de transmissão padrão é 9600, se não for, defina para 9600.

5. Defina a corrente de carga. Defina a corrente de carga.

IMPORTANTE!

Para 5KT, defina para 100 Para 10KT, defina para 160

6. Defina AC Couple como Ativar