Medidor de Energia Conectado à Rede Solis

Baudrate: 9600
Bits de dados: 8
Bits de parada: 1
Paridade: Nenhuma
Endereço Modbus: 1 (padrão) - Faixa: 1 a 254

Dispositivos Suportados

Device Type	Modbus TCP (Ethernet)	RS485
Medidor Solis Grid-Tie (via Inversor/EPM)	✅	✅
Medidor Autarco Grid-Tie (via Inversor/EPM)	✅	✅

Para cabeamento correto de ethernet: siga as diretrizes para cabeamento de ethernet.

Conecte os fios RS485 à porta de comunicação do dispositivo Solis (Inversor ou Export Power Manager).

For correct RS485 wiring: Follow the guidelines for RS485 wiring.
If the wiring shown in the table below is incorrect, please let us know.
There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	Sofar EMS model OM1	Sofar EMS model IG8	RS485-USB converter	RS485-Ethernet converter
A	RS485 A	RS485_POS	RS485 A	TX+
B	RS485 B	RS485_NEG	RS485 B	TX-
GND (optional)	RS GND	GND	Not available	G

You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
Use lower addresses first (1, 2, ...) because the Sofar EMS will find them faster!
For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The Sofar EMS will scan on those first.

Certifique-se de que o dispositivo está configurado com as seguintes configurações Modbus para corresponder às especificações do driver: