Carlo Gavazzi EM500-serien Energimätare

Stödda Enheter

Device Type	Variants	Modbus TCP (Ethernet)	RS485
Carlo Gavazzi EM500 Series		❌	✅

Kabeldragning

RS485

Info

RS485 Wiring

• For correct RS485 wiring: Follow the guidelines for RS485 wiring.
• If the wiring shown in the table below is incorrect, please let us know.
• There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	Sofar EMS model OM1	Sofar EMS model IG8	RS485-USB converter	RS485-Ethernet converter
Terminal 9 / A-	RS485 A	RS485_POS	RS485 A	TX+
Terminal 8 / B+	RS485 B	RS485_NEG	RS485 B	TX-
N/A	RS GND	GND	Not available	G

Konfiguration

Varning

NOTE: RS485 Device Addresses

• You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
• Use lower addresses first (1, 2, ...) because the Sofar EMS will find them faster!
• For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The Sofar EMS will scan on those first.