Schneider-Electric IEM 3000 serie energimålere
Understøttede enheder
| Device Type | Modbus TCP (Ethernet) | RS485 |
|---|---|---|
| Schneider-Electric IEM 3150 | ❌ | ✅ |
| Schneider-Electric IEM 3155 | ||
| Schneider-Electric IEM 3250 | ||
| Schneider-Electric IEM 3255 | ||
| Schneider-Electric IEM 3350 | ||
| Schneider-Electric IEM 3355 | ||
| Schneider-Electric IEM 3455 | ||
| Schneider-Electric IEM 3555 |
Advarsel
Advarsel
Ikke alle Schneider-Electric IEM 3000-seriens elmålere registrerer eksporteret energi! Tjek med elmålerproducenten ved tvivl. Mindst IEM 3150, IEM 3250 og IEM 3350 tillader ikke aflæsning af eksporteret energi.
Tilslutning
Info
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | Sofar EMS model OM1 | Sofar EMS model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| D1 | RS485 A | RS485_POS | RS485 A | TX+ |
| D0 | RS485 B | RS485_NEG | RS485 B | TX- |
| 0V | RS GND | GND | Not available | G |
Konfiguration
Advarsel
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the Sofar EMS will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The Sofar EMS will scan on those first.
Tjek enhedens manual for, hvordan du åbner elmålerens konfigurationsmenu.
