The manual describes the steps to set up DNO Relay Control on the Sofar EMS.
When setting up this integration, permission is granted to DNO to control the necessary devices.
| Device Type | Variants | Supported |
|---|---|---|
| Solar Inverters | All | ✅ |
| Storage Devices | ||
| EV Chargers | ❌ |
| Country | Supported |
|---|---|
| Belgium | ❌ |
| Netherlands | ✅ |
and make sure the to the Sofar EMS.
This external signal operates using digital input devices which are connected to the Sofar EMS. The digital inputs can be connected using or other relay modules.
At least TWO digital inputs are required. These are used for battery control. A third digital input can be connected for PV-curtailment.
In the settings, the grid power limits should be set correctly. Click Settings and check the highlighted setting in the image. If necessary, adjust the settings.
In the next page, you have the option to include/exclude devices for remote control. Ensure to mark all checkboxes of devices you'd like to include.
When using multiple devices of the same type, they are aggregated into one (virtual) asset.
'DNO Relay Control' is now set up on the Sofar EMS.