Esta página describe la comunicación con un inversor híbrido de la serie Autarco LH a través de Modbus-RTU (rs485). Por defecto, el inversor está configurado en la dirección 1. La interfaz RS485 es un conector de 4 pines llamado "COM" ubicado en la parte inferior del inversor detrás de una placa protectora. La posición exacta está marcada en el recuadro naranja en la imagen de abajo:
Observando más de cerca, el puerto se ve así:
Debe usarse un conector adecuado para este conector de 4 pines en el inversor Autarco para conectar al Sofar EMS. En el Sofar EMS, el inversor se puede conectar al puerto RS485. El cableado es el siguiente:
Info
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | Sofar EMS model OM1 | Sofar EMS model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| Pin 3 | RS485 A | RS485_POS | RS485 A | TX+ |
| Pin 4 | RS485 B | RS485_NEG | RS485 B | TX- |
| N/A | RS GND | GND | Not available | G |
Advertencia
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the Sofar EMS will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The Sofar EMS will scan on those first.