In beta and available on request. The additions in this overview require the matching integration or controller update and are not confirmed as part of the standard customer release. Request them through your existing Eniris support conversation. The status applies to these additions, not to every existing function of the devices listed elsewhere on this page.
| Model / system | Beta addition | Validation and conditions |
|---|---|---|
| UMG 800 DefaultList, group 1 | Virtual-meter monitoring with the matching register block | Active DefaultList must match; no load control |
| UMG 800 DefaultList, group 2 | Virtual-meter monitoring with the matching register block | Active DefaultList must match; no load control |
| UMG 800 DefaultList, group 3 | Virtual-meter monitoring with the matching register block | Active DefaultList must match; no load control |
| UMG 800 DefaultList, group 4 | Virtual-meter monitoring with the matching register block | Active DefaultList must match; no load control |
| UMG 800 DefaultList, group 6 | Virtual-meter monitoring with the matching register block | Active DefaultList must match; no load control |
See integration details for connection requirements and operating limitations.
A custom monitoring integration reads the UMG 800 factory DefaultList Modbus address list. Separate variants have been prepared/imported for virtual-meter groups 1, 2, 3, 4 and 6. Each group has its own register block; the active address list must match the driver.
The map is sparse, so requests must not span unmapped gaps. Voltage, current, active power, energy and fundamental reactive-power/power-factor fields are read from the matching group. This integration does not control a load or inverter.