Schneider-Electric PowerTag Energy Sensors
In beta and available on request. The additions in this overview require the matching integration or controller update and are not confirmed as part of the standard customer release. Request them through your existing Eniris support conversation. The status applies to these additions, not to every existing function of the devices listed elsewhere on this page.
| Model / system | Beta addition | Validation and conditions |
|---|---|---|
| Schneider PowerTag Energy | Total and per-phase power factor | Requires the matching monitoring update |
See integration details for connection requirements and operating limitations.
The PowerTag Energy sensors are wireless energy sensors designed to be mounted directly on circuit breakers. They communicate wirelessly to a concentrator/gateway, which in turn communicates via Modbus TCP.
| Device Type | Modbus TCP (Ethernet) | RS485 |
|---|---|---|
| Schneider-Electric PowerTag Energy (R9M Series) | ✅ | ❌ |
Gateway Required: The PowerTag sensors are wireless devices. To communicate with the EMS, they must be paired with a compatible Modbus TCP gateway (e.g., Acti9 Smartlink SI D, Wiser Gateway, or PowerTag Link).
The PowerTag is mounted directly onto the circuit breaker. The voltage measurement cables must be connected to the terminals of the breaker or the load.
For correct ethernet wiring of the Gateway: Follow the guidelines for ethernet wiring.
The driver scans for devices based on the Modbus Address. Ensure the "maxBusAddress" parameter covers the range of addresses assigned to your PowerTags in the gateway.
Monitoring adds both total and per-phase power factor.