Medidor de Energía Conectado a la Red Solis

Baudios: 9600
Bits de datos: 8
Bits de parada: 1
Paridad: Ninguna
Dirección Modbus: 1 (predeterminado) - Rango: 1 a 254

Dispositivos compatibles

Device Type	Modbus TCP (Ethernet)	RS485
Medidor de conexión a red Solis (a través de Inversor/EPM)	✅	✅
Medidor de conexión a red Autarco (a través de Inversor/EPM)	✅	✅

Para el cableado correcto de Ethernet: siga las directrices para el cableado de Ethernet.

Conecte los cables RS485 al puerto de comunicación del dispositivo Solis (Inversor o Gestor de Energía de Exportación).

For correct RS485 wiring: Follow the guidelines for RS485 wiring.
If the wiring shown in the table below is incorrect, please let us know.
There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	Sofar EMS model OM1	Sofar EMS model IG8	RS485-USB converter	RS485-Ethernet converter
A	RS485 A	RS485_POS	RS485 A	TX+
B	RS485 B	RS485_NEG	RS485 B	TX-
GND (optional)	RS GND	GND	Not available	G

You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
Use lower addresses first (1, 2, ...) because the Sofar EMS will find them faster!
For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The Sofar EMS will scan on those first.

Asegúrese de que el dispositivo esté configurado con los siguientes parámetros Modbus para coincidir con las especificaciones del controlador: