In beta and available on request. The additions in this overview require the matching integration or controller update and are not confirmed as part of the standard customer release. Request them through your existing Eniris support conversation. The status applies to these additions, not to every existing function of the devices listed elsewhere on this page.
| Model / system | Beta addition | Validation and conditions |
|---|---|---|
| Fronius Argeno, SunSpec model 704 | Refresh control-enable state after limiting | Does not change support for every Fronius family |
See integration details for connection requirements and operating limitations.
| Device Type | Modbus TCP (Ethernet) | RS485 | Curtailment | Reactive power control |
|---|---|---|---|---|
| GEN24 | ✅ | ✅ | ✅ | — |
| GEN24 Plus | ||||
| Symo | ||||
| Primo | ||||
| Tauro | ||||
| Eco | ||||
| Agilo | ||||
| Verto | ||||
| Verto Plus |
For correct ethernet wiring: Follow the the guidelines for ethernet wiring.
Activate Modbus TCP/IP in the inverter's interface: see the link below for instructions on how to connect to the inverter. https://www.youtube.com/watch?v=T25omrhcroU
Argeno production limiting refreshes the SunSpec control-enable state after each limit request. This targets Argeno control through model 704; it does not change the support status of every Fronius inverter.